P90 Buttstock Extention

Ever felt that the P90 was just too dang small? Perhaps you have long arms and it's uncomfortable to hold? Maybe you want to stash a humongous battery, but there's no room in the default stock? This may just be the solution! With this P90 Buttstock Extention, you can add 2 inches (5cm) or 4 inches (10cm) to the end of your P90.

You simply remove the old buttstock from your current P90, apply the new one, and you're good to go!

Simply remove the old buttplate and put this new one on in the exact same way! The latches are spring-button activated. To remove, just hold the button down and slide back off.

Extra Info

There is also a cavity on the inside that will allow people extra room for cables, batteries, or even tactial snacks. The interior depth of the cavity is 8cm (4-inch version), or 4cm (2-inch version). The profile of the cavity is a slightly irregular shape, but the main gap can fit a 28mm x 50mm profile shape within. This accessory should be compatable with most types of airsoft P90, but please double-check with the images to make sure yours uses the same mechanism.

Materials: PLA+
Average print-time: 10-14 hours
Average finishing-time: 1-2 hours
Average turn-around: 3-5 days