Tiny-Form-Factor Glock Holster

Need an easy place to stash your glock while out on the field? Need to to take up as little space and weight as possible? This might be what you need.

This miniature holster will securely hold your glock again any MOLLE webbing on your gear. Be it on a backpack, chestrig, battlebelt, or helmet. It works via a tight fit, along side a simple spring-operated retention latch. Currently only compatable with KWA/KSC/ASG Glocks.

Please ensure you check which brand your Glock's frame is before buying.

Usage

To attach:
Guide a MOLLE strap into one of the loops. Make sure to guide it behind the longer prong first. Then, fold the strap and thread it behind the shorter prong. Do the same for the second side. The holster should now be securely attached.

To holster the Glock, simply remove your finger from the trigger, and slide the tigger-hole directly onto the top of the holster. There should be a click, and it'll immediately be secured. (Note, the trigger has to be in the 'neutral' position. It wil not holster if you've depressed it and not reset the hammer.) If you need to draw it, place your hand around the grip as you would normally, and place your finger on the grippy pad. Then pull pad backwards to get rid of the latch, and pull your glock outwards. Perform the above steps, but in reverse.

Warning: Please only use this for airsoft. There is a heightened risk of accidental discharge if used negligably.

Materials: PLA+
Average print-time: 4 hours
Average finishing-time: >1 hour
Average turn-around: 2-3 days